Can-Am BOMBARDIER DS650 - Manual (Page 114)

V00I03Y
Insert the needle of spray can in the
cable luber hole.
ƽ
WARNING
Always wear eye protection and
gloves when you lubricate a cable.
NOTE: Place a rag around the cable
luber to prevent the lubricant splash.
Put the lubricant until it passes
through the cable.
Reinstall the cable.
Spray a little quantity of lubricant on
the throttle lever mechanism then
close the housing.
Adjust the throttle lever.
Throttle Lever Adjustment
Slide rubber protector back to expose
throttle cable adjuster.
Loosen lock nut then turn the adjuster
to obtain correct throttle lever free
play.
NOTE: Measure throttle free play at
the tip of throttle lever.
Tighten lock nut and reinstall protector.
V02I04Y
2 3 4 1
A
1. Throttle lever
2. Protector
3. Cable adjuster
4. Lock nut
A. 3 to 8 mm (1/8 to 5/16 in)
Clutch Adjustment
Loosen cable tension by closing the
cable adjuster on the clutch lever.
Adjust clutch release mechanism as
follows.
The release lever must locate on the
spline in such a way that dimension A
is obtained. See the following illustra-
tion.
NOTE: If necessary, unscrew the
Allen socket screw and withdraw re-
lease lever. Replace the lever at the
appropriate position then tighten sock-
et screw to 8 N•m (71 lbf•
in ).
112
_____________________