COBY electronic DTV-102 - Manual (Page 10)

Menu Operation
This chapter describes all of the Menu features and controls provided with the DTV-102.
These menu features are accessed by pressing the MENU button on the CB remote control, and the navigation
buttons ( ) are used to navigate within the sub-menus and to select the desired option. The left ( )
navigation button or the MENU button can be pressed to back up the menu. Pressing the EXIT button will exit
completely out of the menu system. The four sub-menus available are:
• Channel – Auto Scan, Channel Add, Channel Edit, Manual Scan.
• Option – Clock, Aspect Ratio, Language, Audio Language, Closed Caption, DCC View, Sleep Mode.
• Lock – Lock System, Change Password, Block Channel, TV Rating-Children, TV Rating-General, Movie
Rating, Downloadable RRT
4.1 Channel Menu Features
After pressing the MENU button on the CB remote control, use the navigation buttons to highlight
“CHANNEL” and press ENTER or the navigation button to enter.
Auto Scan
The Auto Scan option is used to automatically scan for available digital channels, and should be
used when powering on the CB for the first time. Refer to Section 3.1 for details on how to perform the
Auto Program procedure. If initiated again at a later time, this process will erase all of the previously
saved channels.
- 16 -
0
Figure 12. Channel Sub-menu
Figure 13. Auto Scan Sub-menu
Menu Operation
Manual Scan
The Manual Scan option is used to manually scan for available digital channels and to add additional
channels to the list of available channels; it will not affect the previously saved channels. To use this
feature it is helpful to know the broadcast frequency of the channel to be added, which is different from
the channel number. For instance, your “local channel 4 news” may be on broadcast frequency 35. This
is only important to know when adding a channel that was not detected by the Auto Program function. If
you do not know the broadcast frequency number, see the web site antennaweb.org (for addresses in
the USA.)
Use the navigation buttons to highlight “CHANNEL”, press the navigation button to
select “Mannual Program”, press the navigation button or the ENTER button to access.
The Manual Program window will appear, as shown in Figure 14 below.
Use the navigation buttons to select the RF channel. Press ENTER to add it to the channel
collection. To erase, press ENTER agian.The signal strength information will be indicated by the bars in
the bottom of the manual program window.
- 17 -
0
Figure 14. Manual Scan Window