COBY electronic DTV-102 - Manual (Page 6)

Installation
Output the TV signal from your converter box to the external receiver
You can adopt either of the methods below to output the TV signal to the external monitor.
Refer to A,B in the Figure 4. for better understanding.
A. CVBS Output
Connect the video port (VIDEO) by the supplied RCA cable. (yellow plug).
Connect the audio port (L, R) by the supplied RCA cable (white&red plug).
B. RF Output
Connect the RF OUT port by the RF cable to output the TV signal.
NOTE: Only two channels are available if you chose to output the signal by the RF cable.
Slide the channel switch on the unit’s rear panel to select the channel 3 or the channel 4.
Left Position - - CH3 Right Position - - CH4
C. Analog pass-through Application
- Power On : User Setting the A/V and Modulator 3/4Ch Output
- Power Off : User Setting the analog pass-through Output
1) Power On Application
2) Power Off Application
Power Connection
Insert the power plug into the wall outlet with AC100V-240V, 50Hz/60Hz.
NOTE: Be sure to have all necessary cable connections properly done before connect the power
source.
If the player will not be used for a long period of time, disconnect the power and remove the batteries
from the remote.
Installation
2.4 Remote Control Battery Installation
1. Unlatch the battery compartment cover on the back of the remote control.
2. Insert 2 AAA batteries into the battery compartment, making sure the + and – ends of each battery line up with
the corresponding marks in the battery compartment, as shown in Figure 5 below.
3. Snap the cover back on to the remote control.
2.5 Initial Setup
After the input/output connections have been made, and the DTV-102 has been powered up, a blue screen
should be seen on the TV screen. Pressing the MENU button on the remote control should display the main
menu on the screen, as shown in Figure 6 below. Chapter 3 in this User Guide describes the procedures for
basic TV operations such as scanning for channels, changing channels, language control, and information
display. Refer to Chapter 4 for more details about all of the Menu features and controls.
Figure 6. Main Menu
Figure 5. Install Remote Control Batteries
- 10 - - 9 -
Analog Signal
Digital Signal
ANT IN ANT OUT Audio-R Audio-L Video OUT
Composite Video Output
Audio L/R
MD 3/4Ch Ant In
Analog Signal
Digital Signal
ANT IN ANT OUT Audio-R Audio-L Video OUT ANT IN ANT OUT Audio-R Audio-L Video OUT
Composite Video Output
Audio L/R
MD 3/4Ch Ant In
Analog Signal
Digital Signal
ANT IN ANT OUT Audio-R Audio-L Video OUT ANT IN ANT OUT Audio-R Audio-L Video OUT
Loop-through
Signal
Ant In
Receive the Analog Signal