Vermont Casting Montpelier Wood Insert MEAD3BS - Manual (Page 5)

5
30004451
KT436
upper mounting
bracket
9/03
1/4-20 Wing
Screw
1/4 Flat
Washer
Upper Mounting
Bracket without
Marked “R” Stamping
Boot Boot
KT426
Fig. 6 Install upper mounting bracket.
6. Fasten the upper mounting bracket to both column
assemblies using two (2) 1/4-20 wing screws and
two (2) 1/4 flat washers per side, finger tight. The
distance between the insides of the columns should
measure 29¹⁄₄” (743 mm).
7. Adjust the column/boot length (measure from the
bottom side of the key to the bottom of the boot). It
should measure 22¹⁄₄” (565 mm).
8. Position the surround in front of the insert and, with
the help of an assistant, gently lift the surround up
and over the top sheet metal flange. At the same
time, align the bottom brackets through the slots on
the side flange. As you lower the surround onto the
insert, the side clips and top bracket will engage. If
height and width adjustments are required, lift the
surround up and out. Make the adjustments. Re-
gardless if adjustments were made or not, tighten all
wing screws fasteners and return the surround to the
insert. (Fig. 7)
Assembly complete.
������
�����������������������
����
Top Flange
Side
Flange
KT1014
Fig. 7 Lift surround up and over top flange and up and through side flange holes.