Vermont Casting Montpelier Wood Insert MEAD3BS - Manual (Page 6)

6 30004451
Bevel Cast Trim Surround
Model: LHEABSL
Steel Surround Panels
Models: LHE30SSB, LHE30SLB, LHE30SLGA
Read these instructions before beginning installa-
tion.
Check Contents of Shipping Carton
Examine contents of shipping carton. If any parts are
missing or damaged, contact your local dealer before
starting installation.
Surround Parts
Trim kit assembly
Trim mounting hood
Trim bottom (2) (not used on Montpelier Insert)
Trim deflector (not used on Montpelier Insert)
Hardware package
Installation Instructions
Install the Bevel Cast Trim Surround or Steel Sur-
round Panels after all other installation work has been
completed, thoroughly checked, and tested for proper
operation, leaks and installation requirements.
1. Remove all plastic from trim kit.
2. Before installing trim kit, LHEABSL, some modifica-
tions must be completed. Remove two (2) or four (4)
wing nuts from the back of the trim kit and locate the
trim mounting hood to the two (2) or four (4) outer
holes. Fasten the wing nuts back in position. (Fig. 8)
KT386
Trim mounting
hood
5/1/03 djt
Wing Nut
Trim
Mounting
Hood
Use the Inner
Mounting Holes
KT386
Fig. 8 Adjust trim mounting hood to correct hole location.
Assembly Instructions
1. Once the insert has been installed and tested for
proper operation as directed, stand the Bevel Cast
Trim Surround or Steel Surround Panels in front of
the insert.
2. Position the surround in front of the insert and with
the help of an assistant, gently lift the surround up
and over the top sheet metal flange, at the same
time, align the bottom brackets through the slots on
the side flanges. (Fig. 9)
3. Adjust the surround, left to right, so there is an equal
reveal on either side. Secure by applying downward
pressure until the brackets have engaged onto the
insert. (Fig. 9)
Assembly complete.
KT1015
install trim
3/08 djt
Top
Flange
Side
Flange
KT1015
Fig. 9 Lift surround up and over top flange and up and through side flange holes.