Vermont Casting Montpelier Wood Insert MEAD3BS - Manual (Page 9)

9
30004451
Assemble the Surround to the Insert
1. Before you install the Georgian Cast Surround to
the Montpelier Insert, you must first remove the top
cast filler. To do this remove the two (2) screws on
the back side of the top flange that hold the filler in
place. You can then install the unit onto the insert.
2. Once the insert is installed and tested for proper
operation as directed, stand the Georgian Cast Sur-
round in front of the insert.
3. Position the surround in front of the insert and with
the help of an assistant, gently lift the surround up
and over the top flange, allowing the top brackets to
hook over the flange. At the same time, align the bot-
tom brackets through the slots on the side flanges.
(Fig. 14)
4. Adjust the surround, left to right, so there is an equal
reveal on either side. Secure by applying downward
pressure until the brackets engage onto the insert.
(Fig. 14)
Assembly complete.
������
���������������
����
Figure 14
KT1016
Top Flange Side
Flange
Remove Top
Filler