Zoom H4n - Manual (Page 142)

Ef
fect types on MTR mode and the parameter
141
Effect types on MTR mode and the parameter
(1) POSITION
Before,
After
Selects the insertion position of the EFX module:
"Before" the PREAMP module or "After" the
PREAMP module.
(2) RATE
0 − 50,
Ref. P144
Adjusts the modulation rate.
(3) COLOR
4STAGE,
8STAGE,
INVERT 4,
INVERT 8
Selects the sound type of the effect.
(4) LEVEL 2 − 100
Adjusts the level of the signal after passing the
EFX module.
PHASER This effect produces sound with a pulsating character.
● Compressor/limiter effect types
■
EFX module
(1) THRSHOLD 0 − 50 Adjusts the threshold level of the compressor.
(2) RATIO 1 − 10 Adjusts the compression ratio of the compressor.
(3) ATTACK 1 − 10 Adjusts the attack speed of the compressor.
(4) LEVEL 2 − 100
Adjusts the level of the signal after passing the
EFX module.
RackComp
This is a compressor which attenuates high-level signals
and boosts lowlevel signals.
(1) THRESHOLD 0 − 50 Adjusts the threshold level of the limiter.
(2) RATIO 1 − 10 Adjusts the compression ratio of the limiter.
(3) RELEASE 1 − 10
Adjusts the speed of the limiter release after the
signal falls below the threshold level.
(4) LEVEL 2 − 100
Adjusts the level of the signal after passing the
EFX module.
LIMITER
This is a limiter which attenuates high-level signals that
exceed a certain threshold.
● Modulation effect types
(1) POSITION
Before,
After
Selects the insertion position of the EFX module:
"Before" the PREAMP module or "After" the
PREAMP module.
(2) SENSE
-10 − -1,
1 − 10
Adjusts the effect sensitivity.
(3) RESONANC 0 − 10
Adjusts the resonance characteristic of the ef-
fect.
(4) LEVEL 2 − 100
Adjusts the level of the signal after passing the
EFX module.
AUTO WAH
This is an auto wah effect that tracks the input signal
intensity.
(1) DEPTH 0 − 100 Adjusts the modulation depth.
(2) RATE
0 − 50,
Ref. P144
Adjusts the modulation rate.
(3) WAVE
UP 0 − 9,
DOWN 0 − 9,
TRI 0 − 9
Allows selection of the modulation waveform.
Available settings are UP (rising sawtooth),
DOWN (falling sawtooth), and TRI (triangle).
Higher setting values result in more clipping of
wave peaks, which reinforces the effect.
(4) LEVEL 2 − 100
Adjusts the level of the signal after passing the
EFX module.
TREMOLO This effect periodically varies the volume.