K-Edge K13-510-[color] - Manual (Page 4)

4
WARNING: IT IS STRONGLY RECOMMENDED THAT YOU PERIODICALLY CHECK ALL BOLTS FOR PROPER TORQUE!!!
Lever Action Adjustment:
NOTE: The K13-510 is factory-assembled for immediate use with GARMIN Edge/ Forerunner computers without any
adjustment necessary, IF you wish to adjust the lever action of the TT mount, please follow the steps below to adjust the insert
(K13-503).
1. Loosen the 2x M3 x 6mm Flat Head Screws holding the K13-503.
2. Slowly tighten the 2x M3 x 6mm Flat Head Screws holding the K13-503 (see diagram above).
3. While tightening, check the lever action by rotating 90-Degrees until desired 'feel' is achieved.
4. Once a desired adjustment is met, install the GARMIN computer and check for any sign of play between the arm
(K13-511) and the insert (K13-503). IF play is detected, remove the computer, lightly tighten the 2 x M3 x 6 mm Flat
Head Screws holding the insert (K13-503) until play is eliminated, and desired lever action are both met.
Note: Approximate torque to achieve ideal lever action is 0.45 N-m (+/- 0.1 N-m). This allows for smooth action
while still maintaining a distinctive click at the end of each rotation of 90-Degrees.
Caution: Do not "over-torque" the M3 x 6mm Flat Head screws.
Note: A small amount of thread lock has been applied to the M3 x 6mm bolt at the factory, it is recommended that
an additional amount be added if this bolt were to be adjusted multiple times.