Kenton Modular Solo - Manual (Page 13)

13
P 81 Clock2 divide ratio - (default: d2)
- Sets the ratio of MIDI clocks to output pulses from the Clock2 output.
available values d2 to d24. Note that only the clock1 output can give 24cpqn and 48cpqn.
If set to 2, there will 12 pulses from the clock1 output for every 24 MIDI clocks = 12 cpqn
If set to 24, there will be 1 pulse from the clock pulse output for every 24 MIDI clocks = 1 cpqn
(Note there are 24 MIDI clocks per quarter note)
Below is a table of values you can set the divide ratio to in order to obtain a clock pulse at various
musical time intervals:-
Note type
Divide ratio CPQN (clocks per quarter note)
Crotchets (quarter notes) 24 1
Crotchet triplets 16
Quavers
(eighth notes) 12 2
Quaver triplets 8
Semiquavers (sixteenths) 6 4
Semiquaver triplets 4 6
Demisemiquavers 3 8
Demisemiquaver triplets
2 12
P 82 Clock2 shift (default: 0)
Range 0 to 255
- Sets the number of MIDI clock pulses allowed to pass before the Clock2 output starts giving out clock
pulses. Low values can be used to make Clock1 & Clock2 out of phase with each other. Higher values
can be used to delay the start of one clock relative to the other. This setting has no effect when the
clock has been started, it only has an effect immediately following a MIDI start or continue command.
P 83
Clock2 voltage (default: 05)
- Sets the voltage of the Clock2 output. The following can be selected:
+5v output
[ 05]
+10v output [ 10]
Global Parameters
P 90
Continue = start - (default: on)
- Sets how MIDI Continue messages are treated. The following can be selected:
Off
[oFF]
On [ on]
- when set to on, all continue messages are treated as if they were MIDI start messages.
- when set to off, continue messages will only be treated as start if immediately preceded by a song
position pointer = zero message. Some sequencers use this instead of a start message.
Note this parameter affects the DIN sync 24 output as well as the Clock1 and Clock2 outputs.
P 91 Socket select - (default: MIDI Out/Thru)
- Sets the function of the MIDI Out socket. The following can be selected:
MIDI Out/Thru [MO]
Sync 24
[Syn]
P 92 Sysex Device Number (default :1)
- Sets the SysEx device number for this unit.
Range 1 to 16