Kenton Modular Solo - Manual (Page 5)

5
Below is a list of parameters available to edit. The letters in square brackets show
[where applicable] what will be shown on the LED display.
See page 20 for a full list of all parameters to use as a handy reference.
Menu
number
Parameter (default)
CV & Gate Outputs -
P 01
MIDI receive channel (default :1)
Range 1 to 16
- Sets the MIDI receive channel.
P 02
Retrig Time (default: 5 = 1mS)
Range
off [off] and 1 to 25 (0.2mS to 5mS)
- If set to off (normal trigger mode), the gate just stays on when a new note is played. (no re-trigger)
If set to a number, a valid new note will briefly turn off the gate to retrigger the envelope generators of
your mono-synth. (multiple trigger). The numbers relate to the off time in 0.2mS steps approximately.
P 03
Note priority (default: new)
The following can be selected:
New note priority
[nn]
Low note priority [lo]
High note priority [hi]
- Sets the note priority for the converter.
If set to "nn" then the newest valid note played takes precedence.
If set to "lo" then the lowest valid note played takes precedence.
If set to "hi" then the highest valid note played takes precedence.
NB The MODULAR SOLO has a 5 note buffer memory so that trill effects can be achieved.
P 04
Pitchbend range (default: 2)
Range 0 to 12 semitones.
- The pitch bend range can be changed in semitone steps from zero to 12 semitones
P 05
Portamento controller number (default: 65)
- Sets which MIDI controller will turn on/off the portamento function.
The following can be selected:
On
[on] always on
Off [of] always off
Auto portamento [AU] normally off but legato playing turns portamento on
MIDI controllers #0 to 119 data values of 64 and above =on, 63 and below =off
The standard MIDI controller for portamento on/off is #65 which is the default, but with this command ,
the MODULAR SOLO allows you to use another controller, direct control or Auto Portamento if you
wish.
PARAMETERS