Kenton Pro-SOLO MkII - Manual (Page 10)

10
44 AUX 2 controller number (default: 19)
- Sets which MIDI controller will control pin 3 of the thru socket if Aux 2+3 mode is selected
The following can be selected:
Off
[Of]
Pitch bend [Pb]
Velocity [VL]
Aftertouch
[Af]
MIDI controllers 0-120
Note that pin 3 will be 0 volts if the data value is less than 64 and 5 volts if 64 and above
45 Sysex Device Number (default :1)
Range 1 to 16
- Sets the sysex device number for this unit.
The PRO-SOLO will always respond to controller #64 (sustain pedal) with no adjustment
necessary.
If you want to use the Aux 2+3 outputs, you will need a special cable (which Kenton can
supply) which has a din plug on one end and two 3.5mm jacks on the other. The intended
use for aux 2+3 is to use to control the accent & slide our 5 socket kit for the TB-303.
OTHER USEFUL INFO