Kenton Pro-SOLO MkII - Manual (Page 9)

9
40 Continue = start - (default: off)
The following can be selected:
Off
[oF]
On [on]
- when set to on, all continue messages are treated as if they were MIDI start messages.
- when set to off, continue messages will only be treated as start if preceded by a song
position pointer = zero message. Some sequencers use this instead of a start message.
Affects both the sync 24 output and aux output whenin clock mode.
41 Clock divide ratio - (default: 2)
available values d2, d4 & 2 to 24,
- sets the ratio of MIDI clocks to output pulses from the aux output when in clock mode
NB - Aux1 controller must be set to clock mode.
(if you want an inverted output, swap min and max values (ie - set min to 50 and max to 0)
d2 – special drum machine mode – outputs 24 cpqn – used for many drum machines
d4 – special drum machine mode – outputs 48 cpqn – for Linn & Oberheim drum machines
N.B. Some drum machines use other values e.g. the Roland CR78 uses 12 cpqn (div ratio 2)
If set to 2, there will 12 pulses from the aux output for every 24 MIDI clocks = 12 cpqn
If set to 24, there will be 1 pulse from the clock pulse output for every 24 MIDI clocks = 1 cpqn
(Note there are 24 MIDI clocks per quarter note)
Below is a table of values you can set the divide ratio to in order to obtain a clock pulse at
various musical time intervals:-
Note type
Divide ratio CPQN (clocks per quarter note)
Crotchets (quarter notes) 24 1
Crotchet triplets 16
Quavers
(eighth notes) 12 2
Quaver triplets 8
Semiquavers (sixteenths) 6 4
Semiquaver triplets 4 6
Demisemiquavers 3 8
Demisemiquaver triplets 2 12
42 Thru / Sync 24 / Aux 2+3 select (default :Thru)
The following can be selected:
Thru
[th] The Thru socket functions as a (soft) thru
Sync 24 [sy] The socket functions as a Sync 24 output
Aux 2+3 [Au] Socket pin 1 becomes Aux 2 and Pin 3 becomes Aux 3 – pin 2 is ground
43 AUX 2 controller number (default: 18)
- Sets which MIDI controller will control pin 1 of the thru socket if Aux 2+3 mode is selected
The following controllers can be selected:
Off
[Of]
Pitch bend [Pb]
Velocity [VL]
Aftertouch
[Af]
MIDI controllers 0-120
Note that pin 1 will be 0 volts if the data value is less than 64 and 5 volts if 64 and above