Kenton Pro-SOLO MkII - Manual (Page 5)

5
06 Portamento time / rate (default :98)
Range 0 to 127
- Sets the portamento (glide or slide) time. This can also be adjusted in real time over MIDI
using controller #5 (portamento time). Please note that 0 does not mean portamento off -
to turn portamento off (if it is on) set portamento controller (7) to off.
07 Portamento type (default : fixed rate)
The following can be selected:
Fixed rate
[Fr]
Fixed time [Ft]
- Fixed rate causes the portamento to slide at the rate set in 06, so that the slide time is
proportional to the interval between the start and finish notes.
- Fixed time will attempt to keep the time taken for the slide to be constant, regardless of the
interval between the start and finish notes. (In extreme cases this is not always possible)
08
LFO to CV controller number (default: 1)
The following can be selected;
Off
[Of]
Pitch bend [Pb]
Velocity [VL]
Aftertouch
[Af]
MIDI controllers 0 to 120
09 LFO to CV minimum value (default: 0)
Range
0 to 127
- Sets the level for LFO to CV modulation when the MIDI controller source is at its minimum.
10 LFO to CV maximum value (default: 127)
Range 0 to 127
- Sets the level for LFO to CV modulation when the MIDI controller source is at its maximum.
Note that minimum can be set above maximum so that the controller works backwards.
11 LFO to CV reset value (default: 0)
Range
0 to +127
- Sets the level the LFO to CV modulation will reset to when the PRO-SOLO is powered on or
when it receives a controller reset MIDI command.
12
Coarse Tune / Transpose (default: 0)
Range -24 to +24
- Changing this will change the tuning of the mono-synth in semi-tone steps. If your synth
does not play C when you play a MIDI C (note#36), use this to make it as near as possible.
13 Fine tune (default: 0)
Range
-127 to +127 (approximately a semitone each way)
- Fine tunes the mono-synth.