Kenton Pro-DCB Mk3 - Manual (Page 5)

5
5 AUX reset value (default: 0)
Range
0 to 127
- Sets the level the Auxiliary output will reset to when the PRO DCB is powered up or receives a
controller reset MIDI command.
6 LFO to AUX controller (default: 1)
- Sets which Controller will control the LFO depth applied to the auxiliary.
The following can be selected;
Off
[Of]
Pitch bend [Pb]
Velocity [VL]
Aftertouch
[Af]
MIDI controllers 0-120
7 LFO speed (default: 90)
Range
0 to 127
- Sets the speed of the LFO. This can also be adjusted in real time over MIDI using controller #18
(general purpose controller #3)
NB -
when the unit is receiving MIDI sync, the LFO speed will be directly related to the MIDI clock
rate and the divide ratio. The window will then say SY until either the speed is edited or the unit is
powered on again. If the unit stops receiving MIDI sync, the LFO will continue to run at the same
speed as when the sync stopped.
8 LFO waveshape (default: TR)
- Sets the LFO waveshape. All waveshapes modulate Aux any value between 0 to a positive value,
except triangle, which modulates positive and negative. The waveshapes can be changed in real
time over MIDI using controller #19 (general purpose controller #4). The following may be selected;
(arrow indicates trigger point for MIDI sync).
Triangle [TR] Sawtooth up [SU]
Sawtooth down [SD] PulseWidth 10% [10]
PulseWidth 20% [20] PulseWidth 30% [30]
PulseWidth 40% [40] Square [50]
Sample + Hold [SH] (Pseudo random)
(actually a new S/H level for each trigger)