Kenton Pro-DCB Mk3 - Manual (Page 9)

9
CONVERTER END
The PRO DCB is supplied with a cable which will connect it to all Juno’s and some Jupiter 8’s. The
pin outs of this cable at the converter end are as follows:
n.b. the receive and transmit wires must be separately screened from each other.
8 pin plug (viewed from terminals).
1 Busy (transmit to Juno)
2 Data (transmit to Juno)
3 Clock (transmit to Juno)
1 2 4 Common Ground
3 4 5 5 Busy (receive from Juno)
6 Data (receive from Juno)
7 Clock (receive from Juno)
6 7 8 8 No connection
SYNTHESIZER END
Juno 60 (and some Jupiter 8s) connector
14 way IEEE plug (viewed from terminals).
1 2 3 4 5 6 7
9 10 11 12 13 14 8
PIN 1 - Busy (rx) PIN 2 - Data (rx)
PIN 3 - Clock (rx) PIN 4 - Ground(common)
PIN 5 - Busy (tx) PIN 6 - Data (tx)
PIN 7 - Clock (tx)
No other pins connected. Insulate the screen at this end.
Some Jupiter 8’s are fitted with 20 pin sockets rather than the standard 14 pin version included with
your PRO-DCB These are available from us here at Kenton, alternatively it is possible to make your
own, wiring is as follows. Note that Kenton cannot be held responsible for any problems caused by
leads not supplied by us.
Other Jupiter 8s connectors
20 pin bump polarised socket (viewed from terminals).
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
PIN 1 - Clock(tx) PIN 3 - Data (tx)
PIN 5 - Busy (tx) PIN 7 - Clock (rx)
PIN 9 - Data (rx) PIN 10 - Ground
PIN 11 - Busy (rx)
PIN-OUT DETAILS OF SUPPLIED DCB CABLE
USING YOUR PRO-DCB WITH NON-STANDARD JUPITER 8’S