Keri Systems HPP-100 - Manual (Page 20)

HPP-100 Hand-Held Programmer
Revision 3.3 14
Voiding Consecutive Cards [G]
Voiding Cards removes them from the Master Control Unit’s list of occupied slots. Voiding
cards in Batch Mode is similar to voiding a single card. You must know the slot number
assigned to each card. You do not have to have the cards in hand to void them from the
Master Control Unit.
Example . . . to void a batch of cards in slots 10 through 20:
Press . . . [VOID]
VOID CARD[S]
#: _ _ _ _ TO #: _ _ _ _
Press . . . [0] [0] [1] [0] [ZIP] [0] [0] [2] [0]
(the beginning slot number to
the ending slot number)
VOID CARD[S]
#: 0 0 1 0 TO #: 0 0 2 0
Press . . . [SEND]
Change a Card’s Time Zone [N]
Changing a Card’s Time Zone allows a card’s time zone to be changed to a new value.
You must know the slot number for the card to be changed.
Example . . . to change card 1012 to time zone 3:
Press . . . [3] [1] [0] [1] [2]
CHANGE LEVEL
#: 1 0 1 2 TO #: _ _ _ _
Press . . . [LVL] [3] [SEND]
CHANGE LEVEL
LEVEL: 3