Keri Systems HPP–22 - Manual (Page 4)

HPP–22: Hand Held Programmer
2305 Bering Drive 01831-003 Rev. C
San Jose, CA 95131 USA
(800) 260-5265 (408) 435-8400 FAX (408) 577-1792
Web: www.kerisys.com E-mail: [email protected]
Page 4 of 10
Quick S
tart Guide
HPP–22
NOTE: From this point on, the jumper across JP1 should never be installed on the SM-2000 unless it is necessary to
reset the PINs, or clear system memory and rebuild its database from scratch. Applying power with the jumper installed
on JP1 irretrievably resets the PIN. Applying power a second time and removing the jumper from across JP1
irretrievably erases all card holder data. A database can be restored only if the database has been saved using the D-
Lite program prior to being cleared.
3.5 Enrolling One Card or a Group of Cards
The user assigns a slot number into which the card is enrolled. There are 500 slots available - 1 to 500. The SM-2000
will not allow one card to be enrolled into two slots, nor will it allow a card to be enrolled into a slot already occupied
by another card. Cards enrolled in a group will be assigned sequential slot numbers beginning with the slot number
assigned to the first card.
1. Enter the PIN and press [#]. The reader BEEPs three times and the LED flashes Green, then the LED changes to
blinking Amber indicating that the SM-2000 is in programming mode.
2. Press [1]. The LED changes to steady Green.
3. Enter the slot number to be assigned to the card [nnn] (1 to 500) and press [#]. You can enter one, two, or three
digits as needed. A valid slot entry is confirmed with three BEEPs and a Green LED flash, then the LED changes to
blinking Green.
4. Present the card to the reader. There is one BEEP to acknowledge the card has been read. A valid card enrollment is
confirmed with four BEEPs and one Green LED flash, then the LED returns to blinking Green.
5. Repeat Step 4 for each card to be enrolled.
6. Press [#] to exit enrollment mode. There are two BEEPs, an Amber LED flash followed by a Red LED flash, then
returns to blinking Amber indicating the SM-2000 is still in programming mode.
7. Press [#] to exit programming mode and return to standard operation. The reader BEEPs twice and the LED flashes
Red, then the LED returns to steady Amber.
NOTE: When enrolling cards, if an invalid slot number is entered or an invalid card is presented, the reader BEEPs
once and the LED flashes Red indicating enrollment mode has been exited. The LED returns to blinking Amber
indicating the SM-2000 is back in programming mode.
3.6 Erasing One Card or a Group of Cards from Memory
1. Enter the PIN and press [#]. The reader BEEPs three times and the LED flashes Green, then the LED changes to
blinking Amber indicating that the SM-2000 is in programming mode.
2. Press [9]. The LED changes to steady Red.
3. Enter the slot number [nnn] (1 to 500) for the card to be erased and press [#]. You can enter one, two, or three digits
as needed. A valid slot entry is confirmed with three BEEPs and a Green LED flash, then changes to blinking
Amber indicating the SM-2000 is still in programming mode.
4. If there are more cards to delete, return to step 2.
5. Press [#] to exit programming mode and return to standard operation. The reader BEEPs twice and the LED flashes
Red, then the LED returns to steady Amber.