Keri Systems HPP–22 - Manual (Page 5)

HPP–22: Hand Held Programmer
2305 Bering Drive 01831-003 Rev. C
San Jose, CA 95131 USA
(800) 260-5265 (408) 435-8400 FAX (408) 577-1792
Web: www.kerisys.com E-mail: [email protected]
Page 5 of 10
HPP–22
Quick S
tart Guide
3.7 Enrolling One Card or a Group of Cards to Empty Slots
After you have deleted a card, you may enroll another card into that slot.
1. Enter the PIN and press [#]. The reader BEEPs three times and the LED flashes Green, then the LED changes to
blinking Amber indicating that the SM-2000 is in programming mode.
2. Press [1]. The LED changes to steady Green.
3. Enter the slot number to be assigned to the card [nnn] (1 to 500) and press [#]. You can enter one, two, or three
digits as needed. A valid slot entry is confirmed with three BEEPs and three Green LED flashes, then the LED
changes to blinking Green.
4. Present the card to the reader. There is one BEEP to acknowledge the card has been read. A valid card enrollment
is confirmed with four BEEPs and a Green LED flash, then the LED returns to blinking Green. This will happen
only if the next slot is also empty.
5. Repeat Step 4 for each card to be enrolled.
6. When you have reached the last empty slot, you are automatically taken out of programming mode. There is one
BEEP and the LED flashes Red, then the LED returns to steady Amber.
3.8 Unlock Door Command
1. Enter the PIN and press [#]. The reader BEEPs three times and the LED flashes Green, then the LED changes to
blinking Amber indicating that the SM-2000 is in programming mode.
2. Press [3]. The LED changes to steady Green.
3. Press [1] then [#]. The unlock command is confirmed with three BEEPs and the LED flashes Green, the door is
unlocked, then the LED returns to blinking Amber indicating that the SM-2000 is back in programming mode.
4. Press [#] to exit programming mode and return to standard operation. The reader BEEPs twice and the LED flashes
Red, then the LED changes to steady Green (indicating the door is unlocked). The door will remain unlocked until
it is locked with the Lock Door command.
3.9 Lock Door Command
1. Enter the PIN and press [#]. The reader BEEPs three times and the LED flashes Green, then the LED changes to
blinking Amber indicating that the SM-2000 is in programming mode.
2. Press [3]. The LED changes to steady Green.
3. Press [0] then [#]. The lock command is confirmed with three BEEPs and the LED flashes Green, the door is
locked, then the LED returns to blinking Amber indicating that the SM-2000 is back in programming mode.
4. Press [#] to exit programming mode and return to standard operation. The reader BEEPs twice and the LED flashes
Red, then the LED returns to steady Amber. The door will remain locked until it is unlocked with the Unlock Door
command, an RTE input signal, or a valid card presentation.
NOTE: Use caution if using the HPP-22 to program SM-2000 units in conjunction with the D-Lite TM Cardholder
Database Management Software. Both the HPP-22 and D-Lite are able to enroll cardholders into SM-2000 units. This
means it is possible to have the cardholder D-Lite file for an SM-2000 unit become out of synch with the cardholder file
in the SM-2000 unit if the HPP-22 is used to program new cards. It is possible to synchronize the two sets of cardholder
files by using the merge function in the D-Lite software. Please refer to the D-Lite Software Users Guide (P/N 01869-
001) for information on using this function.