Keri Systems HPP–22 - Manual (Page 8)

HPP–22: Hand Held Programmer
2305 Bering Drive 01831-003 Rev. C
San Jose, CA 95131 USA
(800) 260-5265 (408) 435-8400 FAX (408) 577-1792
Web: www.kerisys.com E-mail: [email protected]
Page 8 of 10
Quick S
tart Guide
HPP–22
4.7 Enrolling One Card or a Group of Cards to Empty Slots
After you have deleted a card, you may enroll another card into that slot.
1. Enter the PIN and press [#]. The LED changes to blinking Amber indicating that the SM-1000 is in programming
mode.
2. Press [1]. The LED changes to steady Green.
3. Enter the slot number to be assigned to the card [nnn] (1 to 500) and press [#]. You can enter one, two, or three
digits as needed. A valid slot entry is confirmed with three BEEPs and three Green LED flashes, then the LED
changes to blinking Green.
4. Present the card to the reader. There is one BEEP to acknowledge the card read. A valid card enrollment is
confirmed with four BEEPs, four Green LED flashes, a Red LED flash, and then the LED returns to blinking
Green. This will happen only if the next slot is also empty.
5. Repeat Step 4 for each card to be enrolled.
6. When you have reached the last empty slot, there are two BEEPs and a Red LED flash, then the LED returns to
blinking Amber indicating that the SM-1000 is still in programming mode.
7. Press [#] to exit programming mode and return to standard operation. The reader BEEPs twice and the LED flashes
Red, then the LED returns to steady Amber.
4.8 Unlock Door Command
1. Enter the PIN and press [#]. The LED changes to blinking Amber indicating that the SM-1000 is in programming
mode.
2. Press [3]. The LED changes to steady Green.
3. Press [1] then [#]. The unlock command is confirmed with three BEEPs and one Red LED flash, the door is
unlocked, and the LED returns to blinking Amber indicating that the SM-1000 is back in programming mode.
4. Press [#] to exit programming mode and return to standard operation. The reader BEEPs twice and the LED flashes
Red, then the LED changes to steady Green (indicating the door is unlocked). The door will remain unlocked until
it is locked with the Lock Door command.
4.9 Lock Door Command
1. Enter the PIN and press [#]. The LED changes to blinking Amber indicating that the SM-1000 is in programming
mode.
2. Press [3]. The LED changes to steady Green.
3. Press [0] then [#]. The lock command is confirmed with three BEEPs and one Red LED flash, the door is locked,
and the LED returns to blinking Amber indicating that the SM-1000 is back in programming mode.
4. Press [#] to exit programming mode and return to standard operation. The reader BEEPs twice and the LED flashes
Red, then the LED returns to steady Amber. The door will remain locked until it is unlocked with the Unlock Door
command, an RTE input signal, or a valid card presentation.