Keri Systems EntraGuard Bronze Residence Guide - Manual (Page 4)

EntraGuard Bronze
1530 Old Oakland Road, Suite 100 01911-003 Rev. C
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 4 of 14
Residence Guide
Telephone Entry
1.2 Call Waiting
If a visitor attempts to notify the residence and the residence telephone is busy, the EntraGuard
Bronze generates a call waiting signal consisting of two, short, high-pitched beeps at three-second
intervals.
1. To put the original call on hold and respond to the EntraGuard Bronze unit, the residence
telephone user presses the key.
2. Once the connection to the EntraGuard Bronze is ended, the residence telephone automatically
reconnects to the call on hold.
1.3 Call Forwarding
If the Call Forwarding feature is enabled, the EntraGuard Bronze dials a programmed remote
telephone number instead of the residence telephone. If the remote number is busy, the EntraGuard
Bronze unit disconnects immediately.
1.4 Remote Connection
Remote Connection allows you to program the EntraGuard Bronze unit from the residence
telephone.
1. The residence telephone can connect to the EntraGuard Bronze at any time by pressing the
key three times with a brief delay between key presses.
2. Once connected, you must enter programming mode (see Section 2.1 on page 6) and then you
can begin programming the EntraGuard Bronze unit.