Keri Systems EntraGuard Bronze Residence Guide - Manual (Page 6)

EntraGuard Bronze
1530 Old Oakland Road, Suite 100 01911-003 Rev. C
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 6 of 14
Residence Guide
Telephone Entry
2.0 Programming
All operating parameters are programmable from either the EntraGuard Bronze’s front panel
keypad or from any telephone in the residence connected to the same phone line as the EntraGuard
Bronze unit. There are 19 commands available.
When entering programming commands, the unit responds to correct entries with a short, high-
pitched tone to indicate the command was accepted. The unit responds to incorrect/invalid entries
with a short, high-pitched tone followed by a low-pitched tone to indicate the command was
rejected.
2.1 Entering and Exiting Programming Mode
The EntraGuard Bronze unit must be in programming mode to set any of the unit’s operating
parameters.
2.1.1 Entering Programming Mode from the Bronze Unit:
1. Press the key three times.
2. Enter the six-digit pre-programmed code (see page 1 for the code assigned to this unit, the
factory default is “999999”).
3. The unit emits a short high-pitched tone to indicate the code was accepted. For security reasons,
the unit does not emit any sounds to indicate if an incorrect code has been entered.
EXAMPLE: Enter the following to enter a Programming Code of “135246.”
2.1.2 Entering Programming Mode from the Residence Telephone
1. Press the key three times.
2. Enter the six-digit programming code (see page 1 for the code assigned to this unit, the factory
default is “999999”).
3. The unit emits a short high-pitched tone to indicate the code was accepted. For security reasons,
the unit does not emit any sounds to indicate if an incorrect code has been entered.
EXAMPLE: Enter the following to enter a Programming Code of “135246.”