LAARS NeoTherm NTV (Sizes 080–850 MBTU/h) - Start Up Guide - Manual (Page 6)

Page 6
LAARS Heating Systems
Adjusting LCD contrast
This feature is used to lighten or darken the display screen.
Navigation
•
Home screen, press “I” Info/Install button
• Use the arrow buttons to highlight “Display Set Up”
• Press OK
• “LCD contrast” is highlighted, Press OK
• Use Left or Right arrow buttons to adjust the brightness, press OK
Customizing the Home Screen
The top five lines on the Home Screen can be customized. An example is if you wanted the
“Delta T” or “Flame Signal” to appear on the Home Screen, you can change the parameters.
Navigation
•
Home Screen, press “I” Info/Install button
• Scroll to highlight “Display Setup”, press OK
• Highlight the line you would like to change,(example ”Line 2 Operating Temp”), press OK
• Scroll to highlight a new parameter, press OK
Change from Fahrenheit to Celsius
Navigation
•
Home screen, press “I” Info/Install button
• Use the arrow buttons to highlight “Advanced Set Up”, Press OK
• Use the Down arrow button to highlight “System Config”, Press OK
• Scroll to highlight “System Config” again, then Press OK
• Screen should be highlighted for “Temperature Units”. If not, use Up/Down buttons to
highlight and press OK.
• Use Down arrow button to select “Celsius”, press OK
Page 6