LABEC J-USRC - Manual (Page 13)

7. : Decrease V alue K ey: Used to change setting value.
8. : RUN/S TOP K ey: S tarts and stops operation.
9. : POWER ON/OFF K ey: Turns Power ON / OFF.
● Key switch function feature of controller.
■ MODE K ey:
­ Press MODE K ey once in Normal Display Mode and changes to RPM (speed) setting mode.
­ Pressing MODE K ey for more than 2 seconds ends RPM (speed) setting mode and returns to
Normal status.
5.2 Configuring controller.
5.2.1 S etting Temperature and Time MODE.
5.2.2 H ow to start operation.
1. Connect the power plug to the power outlet.
2. Turn ON the Main Power S witch
3. Turn ON the POWER ON / OFF K ey located on the temperature controller
4. S et and configure the settings of shaking speed and timer.
5. Press RUN/S TOP K ey once to start the operation.
(Press RUN/S TOP K ey once more to stop the operation.)
6. After the operation is completed, turn OFF the POWER ON / OFF K ey, then turn OFF the
Main Power S witch.
7. Disconnect the power plug from power outlet.
6. Maintenance and service.
6.1 In case of cleaning the equipment.
Laboratory Equipment Pty Ltd – Operation Manual J­USRC Shaker Page 10