Trouble shooting, Aftersales service – LABEC J-USRC User Manual
Page 14
●
Disconnect the power plug from power outlet.
●
Clean the exterior of the equipment with sponge or soft clothes getting wet by neutral cleaner.
●
Clean with dry clothes.
●
Do not use organic solvent.
●
Do not use flammable or volatile chemicals such as benzene, alcohol to clean.
●
Do not use flammable or volatile chemicals such as benzene, alcohol to clean the
equipment.
●
This equipment is not designed nor manufactured Explosionproof, so never place highly
flammable material or explosive material on the equipment, which may cause an explosion
or a fire.
6.2 Cleaning electric parts.
●
Clean with dry clothes.
6.3 When the equipment is not used for long time.
●
Remove power plug from power outlet.
●
Clean with soft clothes.
●
Pack the equipment in a appropriate way and store in a safe place for storage.
7. Trouble shooting.
1
In case apparatus fails to work at all:
●
Control unit switched off: Ensure unit is on.
●
Power supply shortage:
Refer to specification and check whether sufficient power is being
supplied.
●
Check if lamp is turned OFF: Check unit in a power outlet that is known to work.
If still does not work, contact your local LABORATORY EQUIPMENT PTY LTD agent/distributor and
have it repaired.
2
Is the equipment inclined? Install the equipment in a flat stable location.
3
Fuse failure: Check whether the fuse is blown, if so replace fuse with a new one.
(*
Refer to the specification section of this manual for specification of the fuse.)
4
In case general failure:
Check unit in a power outlet that is known to work. If still does not work,
contact your local LABORATORY EQUIPMENT PTY LTD agent/distributor & have it repaired.
5
Due to control unit failure:
Contact your local LABORATORY EQUIPMENT PTY LTD
agent/distributor & have it repaired.
8. Aftersales service.
8.1 Free repair
Faults happening during normal operating conditions or caused by manufacture of the
product can be repaired for free within 1 year from purchase date (pressure vessels are not
covered). Please supply the following items when requesting A/S (After sales service).
●
Part and condition that generated fault.
(It is necessary to explain in detail within limit of possibility.)
●
Model name
●
S erial Number
●
Purchase date (year, month, date)
Laboratory Equipment Pty Ltd – Operation Manual JUSRC Shaker Page 11