LABEC Z-L-530 - Manual (Page 9)

and make the 4 supporting legs sustain evenly on the table-board, ensure that the mounting bracket and the
table-board are fixed and don't swag.
3.4 Connect the power correctly
Please use power cord separately for the centrifuge. And make sure of that the cord is grounded well and
the power cords of the centrifuge meet the safety requirement of the country or the region. The supply
voltage and supply frequency should meet the requirements of this manual or the specifications of mark of
the centrifuge.
Please use the power cord attached with the machine, connect to electric outlet correctly and connect to
main power supply fixed. When the switch of power supply is closed, it's: “︱”;and when it's switch off,
it's “O”.
4. Operating instructions
4.1 Introduction of control panel and display interface
Figure5: schematic drawing of control panel
Introduction of Figure 5, Function of control display panel:
1 open the door key
2 stop key
3 start / moment centrifugal keys
4 key setting knob
Display interface function description:
5 speed
6 parameter storage program number
7 set temperature ( Temp )
The 8 set of centrifugation time ( Time )
9 set speed ( Speed ) / centrifugal force ( Rcf )
10 real time speed ( Speed ) / centrifugal force ( Rcf )
11 real time temperature
The 12 running time countdown
13 fault display label (only in the event of a failure. )
14 rotor number ( Type )
15 door state display / operation state display
16 expression condition
4.2 Start the machine
Connect one side of the power cord which is attached with the machine to the power outlet of posterior of the
left side of the machine; and connect another side to mains supply which should be separate outlet. Power
range of this device is AC230V 50Hz/60Hz. After connection, switch on the bottom left of the right side of
the machine. After a short buzz of the buzzer, the red light on the control panel will be on. It will enter display
of main interface after self-examination. Then we can do next step.