Lippert Components In Wall Slide-Out System - Manual (Page 4)

Rev: 11.21.2014
Page 4
IN-WALL™ Slide-out Owner's Manual
Troubleshooting
Controller Overview (B Version)
Motor 1 Connector
Switch
Connection Motor 2 Connector
Power
Connection
Controller Version
Fig. 2
Status LEDs: 2 LEDs, 1 green and 1 red, are provided to indicate current controller status and faults.
Power Connection: 12V DC input. Unit will operate from 8V DC to 18V DC.
Switch Connection: Spade connection for the switch wiring.
Motor 1 Connector: Power and encoder input for motor 1.
Motor 2 Connector: Power and encoder input for motor 2.
NOTE: Version B motor harnesses have five wire in-line connectors at the controller and the molded
connector at the motor end (Figs. 3 and 4). Wire colors match with color codes on control board. It
does not matter which motor is 1 or 2.
Red LED
Green LED
Fig. 3 - Controller Connections Fig. 4 - End of Motor Harness