Lippert Components In Wall Slide-Out System - Manual (Page 5)

Rev: 11.21.2014
Page 5
IN-WALL™ Slide-out Owner's Manual
Controller Overview (C-2 Version)
Motor 1 Connector
Motor 2 Connector
Power
Connection
Controller Version
Fig. 5
Switch
Connection
Status LEDs: 2 LEDs, 1 green and 1 red, are provided to indicate current controller status and faults.
Mode Button: Used to engage the electronic manual override.
Power Connection: 12V DC input. Unit will operate from 8V DC to 18V DC.
Switch Connection: Spade connection for the switch wiring.
Motor 1 Connector: Power and encoder input for motor 1.
Motor 2 Connector: Power and encoder input for motor 2.
NOTE: Motor harnesses have Molex® connectors at the controller and the molded connector at the motor
end (Figs. 6 and 7). Wire colors match with color codes on control board. It does not matter which
motor is 1 or 2.
Red LED
Green LED
Mode
Button
Fig. 6 - Controller Connections Fig. 7 - End of Motor Harness