Longshine LCS-8038TXR7 - Manual (Page 3)

1. Introduction
Congratulations on the purchasing of your new 10/100
NWay Fast Ethernet PCI adapter. This document describes
the Installation of network adapter. This adapter supports
10BASE-T/100BASE-TX Fast Ethernet and complies with
the electrical and protocol requirements of the PCI Local
Bus Specification, revision 2.2. The Wake-On-LAN feature
is optional for the adapter.
1.1 Features
The 10/100 Fast Ethernet PCI adapter is a cost effective,
high-performance network interface card. It operates in
10BASE-T and 100BASE-TX modes and integrates easily
with Fast Ethernet hub and switch.
y IEEE 802.3 10BASE-T and 100BASE-TX standards
y 32-bit bus master for high throughput and low CPU
utilization
y Wake-On-LAN feature is optional for different
hardware version
y Full-duplex operation at both 10Mbps and 100Mbps
y Supports 10/100Mbps auto-sensing capability
y Rich diagnostic LED mounted on bracket for easily
viewing and troubleshooting
y Single shield RJ-45 connector for using at either
Speed (Category 3, 4 or 5 UTP cable for 10Mbps
Operation, and Category 5 UTP cable for 100Mbps
Operation)
y Plug and Play Installation.
y Test program (include Wake-On-LAN events)
y Network drivers on the diskette for Windows 95, 98,
ME, NT, 2000, XP, NetWare, SCO Unix and Packet
driver.
y FCC, CE certification
1.2 System Requirements
To use the adapter, you need the following components:
y
One PCI master mode expansion slot that is
compliant with PCI bus specifications, revisions 2.2
y A 3.5-inch,1.44MB diskette drive
y The following cables:
To operate at 10Mb/s, a Category 3, 4, 5 UTP Cable
E-3
To operate at 100Mb/s, a Category 5 UTP cable