Longshine LCS-8038TXR7 - Manual (Page 9)

To wake up Target Machine with Magic Packet
Step1: Target Machine:
Target Machine is necessary to use the WOL cable
link the Wake On LAN connector on adapter with
your motherboard. Check BIOS <POWER
MANGEMENT SETUP> ACPI, Wake On LAN
function must be enable.
Step2: Target Machine:
Select <Target Machine> then the system will setup
wakeup event and wait a magic packet to do system
wakeup
Step3: Master Machine:
Select <Magic Packet> to send a magic packet and
wake up the target machine. The MAC address of
target machine will be asked for key-in, like
00 e0 7d c0 00 02.
Step4: Target Machine:
ACPI Testing events will be show
Device State 1: PASS
Device State 2: PASS
Device State 3: PASS
Step5: Target Machine:
Put the Target Machine to power down mode.
Step6: Master Machine:
Send a magic packet to wake up Target Machine.
Test the Wakeup Frame
Step1: Target Machine:
Select <Target Machine> then the system will setup
wakeup event and wait a magic packet to do system
wakeup
Step2: Master Machine:
Select<WakeUp Frame> to send a wakeup frame.
Step3: Target Machine :
ACPI Testing events will be show
Device State 1: PASS
Device State 2: PASS
Device State 3: PASS
Note:
E-9
Adapter testing program can not be used in Windows
95/98 DOS mode. Do not load any device drivers,
memory manager, and anti-virus software. The testing
program only can work in clean DOS prompt.