MF Digital Spectrum 2 Thermal (Rev: 03/05/01) User Manual
Page 33
Spectrum2 Printer Operator’s Guide
Document Revision: 100102
32
•
Ribbon can also be wound by
pressing Start and Print buttons
simultaneously
•
Ribbon change complete - check
software settings for proper color or
black ribbon selection prior to
printing.
Note:
When installing a mono-color blue or red ribbon, please follow the
instructions below in order to disable the ribbon sensor:
•
Press and hold the print button
•
Turn on the power to the printer
•
Continue to hold the print button down for 25 seconds
•
Release the print button when the ribbon spools
•
The ready light will come on at this point
•
If done improperly, a large amount of ribbon will be spooled and the status
button will blink twice.
•
There is no need to enable the ribbon sensor if you want to install a color or
black ribbon. Simply turn the printer off and on again, and the ribbon
sensor will be enabled.