MF Digital Spectrum 2 Thermal (Rev: 03/05/01) - Manual (Page 34)

Spectrum2 Printer Operator’s Guide
Document Revision: 100102
33
Installing Spacer for Color, Mono-Color Blue and Red Ribbon)
A spacer is used to prevent color, mono-color blue and red ribbons from sliding
back and forth on the supply spindle. Please see below for installation instructions.
• The spacer should be positioned opposite the metal pin that fits into the ribbon core.
• Slide the spacer onto the supply spindle as seen below.
• After the spacer is placed onto the supply spindle, install the ribbon into the printer as
you normally would.