MF Digital SCRIBE EC_PC_manual - Manual (Page 30)

CD-3706/P Operator’s
Guide
Document Revision: 030501.1
Scribe EC Standalone Series
Operator’s Guide
Document Revision: 011804
Page 30
Aligning the Drive Bay
Please follow the instructions below to align the drive bay on the Scribe EC
Standalone.
• From the main operating screen depicted below:
• Press the “4” key. You will then be prompted to “Start Loader Test
Mode?”. Press the “Start/Yes” key to enter “Loader Test Mode”
•
The following screen will appear. Place a CD in the 1 st input area.
•
To align the drive tower, first press the number with corresponds to the
“C” command for calibrate. Then press “I” for input. This will pick up
a CD from the input area and place the CD in the drive. Inspect the
placement of the CD and align the drive tower accordingly.
•
After inserting a CD, press “A” for accept, and the arm will pick the CD
out of the drive and place on the output spindle.
• Repeat process as necessary until you are satisfied with the alignment of
the drive bay.