MF Digital SCRIBE EC_PC_manual - Manual (Page 57)

CD-3706/P Operator’s
Guide
Document Revision: 030501.1
Scribe EC Standalone Series
Operator’s Guide
Document Revision: 011804
Page 57
Utilizing the Scribe EC Standalone Series Client
The Scribe EC Standalone series has a client feature which enables a
remote user.
Configuring the Scribe EC Standalone Series
• Connect the Scribe EC Standalone Series to your network using the
RJ-45 connector on the back of the system.
• Turn on the Scribe EC Standalone Series
• Wait for the Scribe EC Standalone Series to boot up, you will see:
• Press the “7” key, you will see:
• Press the “START/YES” key, you will see:
• You must leave “MF” at the front of the name. You should name it
“MF001” for example.
• Press the “START/YES” key, you will see:
• Press the “Stop No” key if the network does not use DHCP or press
the “START/YES” key if the network does use DHCP. If you press
the ““START/YES” “ key you will be prompted to Restart the
system, if you press the “Stop No” key you will see:
• Enter the 4 sets of numbers of the IP address, one set at a time. After
each octet press the “START/YES” key. Do not enter an IP address
of a machine that is already on the network. When you have entered
in the entire IP address, you will see: