MF Digital Director EC Publishing Series - Manual (Page 17)

DIRECTOR EC Series Operator’s Guide Document Revision: 080904
Page 16
Starting the DIRECTOR EC For The First Time
Before CD creation or duplication can begin it is necessary to review a few
details.
Power Connection And Settings
• Make sure the DIRECTOR EC power switch is set to the off position.
Also, set the PC switch to off or “0”.
• Verify that the voltage selector switch on the back of the unit is set
correctly. The DIRECTOR EC supports both 115 VAC and 230 VAC at
50 ~ 60 Hz. Please confirm that the correct voltage (115 VAC for North
America) has been selected.
• Plug one end of the supplied power cord into the receptacle at the rear
of the unit and the other end into the wall or UPS power outlet.
0
CAUTION
Always use properly grounded receptacles, or severe damage
to your system may result. The use of a surge protector or
Uninterruptible Power Supply (UPS) is highly recommended.
The DIRECTOR EC use Microsoft’s Windows 2000 Professional for
their operating system. To get the most out of the DIRECTOR EC it is
recommended that users supplement this manual with a Windows 2000
Professional guide.
Note: