Compaq CP-2E - Manual (Page 16)

Installation and Configuration
iPAQ Connection Point CP-2E User Guide 2–3
1. Plug one end of the supplied Ethernet cable into the port labeled 1 on
the back of the Connection Point CP-2E. 1
2. Plug the other end of the Ethernet cable into the Ethernet port on the
PC. 2
Powering Up
1. Plug the power adapter into an AC power outlet. 1
2. Connect the output of the power adapter to the 12V DC power input
on the rear of the Connection Point CP-2E. 2
The Power LED on the front panel should light up immediately.
The Connection Point CP-2E runs a series of self-tests to verify that it is
operating properly. The Test LED on the front panel remains lit while the
self-tests are running. The Connection Point CP-2E is ready to use when
the Test LED turns off.
Client PC Configuration
The configuration procedure for Windows 98 and ME clients is described
below.
Note: The configuration procedure for Windows XP, 2000 and NT4.0 are
described in Chapter 3, Adding PCs to Your Network.
The Connection Point CP-2E automatically provides the following
TCP/IP configuration information to your PC: