Motion Pro 08-0430 - Manual (Page 2)

Using the Stud Installation Tool P/N 08-0431
I8-0430 2 of 2 7.29.08
1-Push the studs into the holes in the track by hand
until the tip protrudes and there is enough tension to
hold the stud in place while you position the Stud
Installation Tool P/N 08-0431.
2-Position the Stud Installation Tool over the stud so
that the borehole of the tool is over the tip of the stud
and the round platform is under the head of the stud
(underside of track).
3-Using both hands, spread the handles of the tool apart
until the head of the stud is pushed flush with the
underside of the track. Rotate the track to a new area
and repeat the procedure until all of the studs have been
pushed into place.
4-Install the stud plate and nut onto each stud, and
tighten each nut down according to the stud
manufacturer’s specifications.