Motion Pro 08-0434 User Manual
Page 3
7. Place a light coat of grease or assembly lube on both the bearing and the bearing extractor to prevent
damage during the installation. Rotate the flat portion of the installation adapter so it is aligned with the
flat on the shock mount boss. Using a mallet, drive the bearing into the boss until it is fully seated against
the installation adapter.
8. Using the extraction adapter, carefully install the new seals until they are flush with the sides of the shock
mount boss.
We at Motion Pro hope you have found these instructions useful and that this tool has
made the job as easy as possible . If you have any further questions regarding this or
any of our products please see us at www.motionpro.com or call at (650) 594-9600
PAGE 3
040I08-0434
11/2010