Motion Pro 08-0581 - Manual (Page 4)

I08-0581 4 of 4 05/2014
8. Double check the calibration screws
and o-rings to make sure they are free
of any dust or debris and then gently
thread them into the reservoir until they
bottom out. They do not need to be
tight.
9. Place the reservoir in the housing, and check one last time that the o-rings and tubes are still fully
seated before you put the housing back together. Starting with the innermost screws and working
outward, gently hand-tighten each screw until the housing is closed around the entire perimeter.
Replace the rubber feet. Your SyncPRO™ is now ready for use. Remember to check and set
your engine idle to the proper RPM before hooking up the
SyncPRO™ for its next use.
9
.
8
.