Mytek Digital Protools HD DIO Card (ver. 1.1 / Oct 2010) - Manual (Page 19)

Mytek Protools-HD DIO Card – User Manual
Typical Configurations
Single 8x192 ADDA converter
1. Connect the 8X192 ADDA (through Primary Port) to the
Pro Tools interface card in a computer.
2. Turn on the computer and converter.
3. Set the converter to work with internal clock.
✔
EXT LED shouldn’t be lit.
✗
If LED is lit, press and hold EXT CLOCK SOURCE
button.
4. Launch the Pro Tools application.
5.
Open Setup > Hardware Setup and check:
✔
Is the 8X192 ADDA Mytek Digital converter
properly detected as 192 I/O?
✔
Are input and output signals assigned in the Input
and Output tab?
✗
If not, close the Pro Tools application, turn off the
converter and check connection between the HD-
DIO card and the computer.
Setup > Hardware Setup
User Manual ver. 1.1 / oct 2010 www.mytekdigital.com Page: 19 / 29