NORAC UC5-BC-AL Manual - Manual (Page 25)

21
A list of connected modules will
be displayed. Make sure the
modules match your system
modules.
If the list of modules matches the
currently installed modules, press
the PROCEED button.
You will then be instructed to
hold the PROCEED button. The
terminal will display “Cruising”.
The terminal will then instruct you
to exit the cab and pull the boom
tip down towards the ground, and
then release the boom.
If you wish to skip the boom
geometry test, press the
PROCEED button.
Ensure you stay a minimum of 3
feet (1 m) away from any of the
sensors. When finished, return to
the cab.