NORAC UC5-BC-AL Manual - Manual (Page 29)

25
Select the sensor position that
you are configuring and select the
appropriate serial number from
the second drop down menus.
Select the check to confirm.
Continue this for each of the
sensors, if necessary.
To set the sensor height, select
the appropriate sensor. Measure
from the ground to the bottom
of the nearest sprayer nozzle tip.
Click on the keypad beside the
nozzle height textbox and enter
the measured number.
Repeat this to enter the correct
height for each of the sensors.
When you change the roll sensor
value the text changes from
Nozzle Height to Measured Roll.
This should be zero when the
boom is level.