NORAC UC5-BC-AL Manual - Manual (Page 38)

34
7.4.5 Remote Switch Setup
Remote switches allow manual override of the UC5 system. Depending on the input, this may
cause a complete override or a partial override of UC5 automatic control. Each of the UC5
functions requires a manual override.
Before manually setting up the remote switches it is recommended that you attempt an
automatic setup. By starting an automatic setup the default values will be set up for the remote
switches.
Navigate to the UC5 setup
screen.
From the UC5 setup window,
make sure the drop down box
under the Norac logo is
populated.
Press the Sensors and Valve
Drivers button.
Select the Switch tab.
This screen displays a list of
currently configured remote
switches. If a function is not
displayed in this screen, then a
switch has not been setup for it.
To setup a function, press the
Add button.