OFM ORO300 - Manual

Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Model ORO300
Designer High-Back Multi-Task Chair
WEIGHT CAPACITY: 300 lbs.
Parts Listing
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
[email protected]
05.29.2013
A
Chair Back
1 Unit
B
Chair Seat
1 Unit
C
Chair Base
1 Unit
D
Casters
5 Units
E
Chair Arms
2 Units
F
Seat Mechanism
1 Unit
G
Gas Lift
1 Unit
H
Telescopic Bellows
1 Unit
I J
0.75” Screws
10 Units
Arm Caps
8 Units
Allen Wrench
1 Unit
K
1.25” Screws
2 Units
L
STOP
Assembly Instructions
Tools Needed: Allen Wrench - included
Please read all instructions before assembly.
Step 1: Insert Casters (D) into Chair Base (C). Insert Gas Lift (G) into Chair
Base (C) and cover with Telescopic Bellows (H).
Step 2: Attach Seat Mechanism (F) to the Chair Seat (B) with .75” Screws (I) at
back of seat and 1.25” Screws (J) at front of seat, using the Allen
Wrench (K) that is provided. Tension control knob should face front.
Step 3: Attach Chair Seat (B) to Chair Base (C) by inserting the top of the Gas Lift (G)
into the center hole of the Seat Mechanism (F), and press down firmly to secure.
Step 4: Attach Chair Arms (E) to Chair Seat (B) using .75” Screws (I) and Allen Wrench (K).
The tablet arm goes on the right side.
Step 5: Attach Chair Back (A) to Chair Arms (E) using .75” Screws (I) and Allen Wrench (K).
Step 6: Cover screw holes with Arm Caps (L).
1 H
G
2
B
3
I
front
J
K
B
F
D
C
4
B
E
I
6
A
5
L
E
I
E
Product Web Page & Video