OFM ORO100 - Manual

Product Web Page & Video
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Model ORO100
Executive High-Back Body Bolster Multi-Task Chair
WEIGHT CAPACITY: 350 lbs.
Parts Listing
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
[email protected]
05.29.2013
G
Gas Lift
1 Unit
H
Telescopic Bellows
1 Unit
I
0.75” Screws
10 Units
J
1.25” Screws
2 Units
Allen Wrench
1 Unit
K
Arm Caps
8 Units
L
1
H
G
2
B
3
4
B
E
I
6
A
5
L
I J
K
B
F
D
F
Seat Mechanism
1 Unit
E
Chair Arms
2 Units
E
I
E
C
D
Casters
5 Units
C
Chair Base
1 Unit
A
Chair Back
1 Unit
B
Chair Seat
1 Unit
STOP
Assembly Instructions
Tools Needed: Allen Wrench - included
Please read all instructions before assembly.
Step 1: Insert Casters (D) into Chair Base (C). Insert Gas Lift (G) into Chair
Base (C) and cover with Telescopic Bellows (H).
Step 2: Attach Seat Mechanism (F) to the Chair Seat (B) with .75” Screws (I) at
back of seat and 1.25” Screws (J) at front of seat, using the Allen
Wrench (K) that is provided. Tension control knob should face front.
Step 3: Attach Chair Seat (B) to Chair Base (C) by inserting the top of the Gas Lift (G)
into the center hole of the Seat Mechanism (F), and press down firmly to secure.
Step 4: Attach Chair Arms (E) to Chair Seat (B) using .75” Screws (I) and Allen Wrench (K).
The tablet arm goes on the right side.
Step 5: Attach Chair Back (A) to Chair Arms (E) using .75” Screws (I) and Allen Wrench (K).
Step 6: Cover screw holes with Arm Caps (L).
front