On Networks N300RM User Manual - Manual (Page 92)

Virtual Private Networking
92
N300 WiFi ADSL2+ Modem Router (N300RM)
If the remote endpoint has a dynamic IP address, select Dynamic IP Address. No
address data input is required. You can set up multiple remote dynamic IP policies, but
only one such policy can be enabled at a time. Otherwise, select an option (IP address
or domain name) and enter the address of the remote VPN endpoint to which you want
to connect.
VPN Manual Policy Local LAN Settings
The remote VPN endpoint has to have these IP addresses entered as its remote addresses.
• Subnet Address
. Enter the network mask.
• Single PC - no Subnet . Select this option if there is no LAN (only a single computer) at
the remote endpoint. If this option is selected, no additional data is required.
• Single/Start IP Address . The IP address for a single address, or the starting address for
an address range used on the LAN. If you want to make a single server on your LAN
available to remote users, use a single address.
• Any . The remote VPN endpoint can be at any IP address.
• Finish IP Address . For an address range, enter the finish IP address. This has to be an
address range used on your LAN.
• Subnet Mask . Enter the network mask.
VPN Manual Policy Remote LAN Settings
The remote VPN endpoint has to have these IP addresses entered as its local addresses.
• IP Address . Select Single PC - no Subnet if there is no LAN (only a single computer) at
the remote endpoint. If this option is selected, no additional data is required. The typical
application is a computer running the VPN client at the remote end.
• Single/Start IP Address . Enter an IP address on the remote LAN. You can use this
setting to access a server.
-
For a range of addresses, enter the starting IP address. This has to be an address
range used on the remote LAN.
- Any . Any outgoing traffic from specified Local IP computers triggers an attempted
VPN connection to the remote VPN endpoint. Be sure you want this option before
selecting it.
• Finish IP Address . Enter the finish IP address for a range of addresses. This has to be
an address range used on the remote LAN.
• Subnet Mask . Enter the network mask.
VPN Manual Policy ESP Settings
ESP (Encapsulating Security Payload) provides security for the payload (data) sent through
the VPN tunnel.
• SPI . Enter the required security policy indexes (SPIs). Each policy has to have unique
SPIs. These settings need to match the remote VPN endpoint. The in setting here has to