Cisco 2600 Series - Manual (Page 7)

Rack-Mounting the Cisco 2600 Series Router 7
Installing the Router in a Rack
Installing the Router in a Rack
After the brackets are secured to the chassis, you can rack-mount it. Using screws that you provide,
attach the chassis to the rack. (See Figure 7 and Figure 8).
Figure 7 Mounting the Chassis in a Rack (19-Inch Rack with a 17.5-Inch Opening)
Figure 8 Mounting the Chassis in a Rack (19-Inch Rack with a 17.75-Inch Opening or a
23- or 24-Inch Rack)
What to Do after Installing the Router Hardware
After you have installed the router, make all necessary LAN and WAN connections, connect the
power cable to the rear panel of the router and the power source, and then power it ON. (If the router
does not power ON, proceed to the “Troubleshooting the Router” appendix in the Cisco 2600 Series
Hardware Installation Guide included in your router package.)
For information on making LAN and WAN connections, refer to the hardware guides included in
your router package.
For initial software configuration information, refer to the Software Configuration Guide included
in your router package.
110V 60 Hz 1.6A MAX
27718
The second bracket attaches to the rack at the other side of the chassis.
The brackets can also be installed with the front panel forward.
19-inch rack
110V 60 Hz 1.6A MAX
27717
19-inch
brackets
23-inch and 24-inch
brackets