Compaq Presario 3000 Series - Manual (Page 52)

4-6 Compaq 3000 Series UPS Operation and Reference Guide
Changing Configuration Parameters
The Configure mode may be entered from the Operate or Standby mode.
IMPORTANT: If the STANDBY button is pressed while in the Configure mode, the UPS will
enter Standby mode, and power to the load segments will cease.
4
1
2
3
Figure 4-3. Configure mode controls
1 ON LED (LED 16)
2 ON button
3 STANDBY button
4 TEST/ALARM RESET button
To change configuration parameters:
1. Place the UPS in Configure mode by pressing the ON (
2) and
TEST/ALARM RESET (
4) buttons simultaneously. Release the buttons
when the acknowledgement beep sounds.
2. The top left LED on the front panel LED display should begin to blink,
indicating that configuration parameter 1 is selected.
3. To determine if the selected configuration parameter value is ON or
OFF, check LED 16 (
1)—if LED 16 is ON, the selected parameter is
also ON.