Philips 27PT6442-37 User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
IMPORTANT SAFETY INSTRUCTIONS
Read before operating equipment
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6
.
Qean only with a dry doth.
7. Do not block any of the ventilation openings. Install in accor
dance with the manubcturers instructions.
8
.
Do not install near any heat sources sudi as radiators, heat
registers, stoves, or other apparatus (induding amplifiers) that
produce heat
9. Do not defeat the safety purpose of the polarized or grounding-
r
plug. A polarized plug has two blades with one wider than
other.A grounding type plug has two blades and third
grounding prong. The wide blade or third prong are provided
for your safety.men the provided plug does not fit into your
outlet, consult an electrician for replacement of the obsolete out
let
10. Protect the power cord from being walked on or pinched par
ticularfy at plugs, convenience receptades, and the point where
they exit from the apparatus.
11. Only use attadiments/accessories specified by the manufacturer.
12.
Use only with a art, stand, tripod, bracket, or
table specified by the manufacturer, or sold with
VTS
f
2 QT is used, use aution
when moving the art/apparatus combination to
avoid injury from tip-over.
l3.Unplug this apparatus during lightning storms or when unused
for long periods of time.
l4.Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any w^,
such as power-supply cord or plug is damaged, liquid has been
spilled or objects have fallen into apparatus, the apparatus has
been exposed to rain or moisture, does not operate nomially, or
has been dropped.
l5.This product may contain lead and mercury. Disposal of these
materials may be regulated due to environmental considerations.
For disposal or reccing information, please contact your loal
l6.Damage Retiring Service - The appliance should be
serviced by qualified service personnel when:
A. The power supply cord or the plug has been damaged; or
B. Objects have Bllen, or liquid has been spilled into the appliance'
or
C. The appliance has been exposed to rain; or
D. The appliance does not appear to operate normally or exhibits
a marked change in performance; or
E. The appliance has been dropped, or the enclosure damaged.
Note to the CATV system installer: This
remincier is provicieci to call the CATV system
installer's attention to Article 820-40 of the
NEC that provides guidehnes for proper
grounding and, in particular, specifies that the
cable ground shall be connected to the ground
ing system of the building, as close to the point
of cable entry as practical.
IT.Tilt/Stabirity
- All televisions must comply with recommend
ed international global safety standards for tilt and stability
prMerties of its abinet design.
* Do not compromise these design standards by applying exces
s'lve pull force to the front, or top, of the abinet wtiidi could
ultimately overturn the product
* Also, do not endanger yourseH, or children, by placing electroni
c equipment/toys on the top of the abinet Such items could
unsuspectingly fall from the top of the set and ause product
damage and/or personal injury.
18.
Wall or Ceiling Mounting - The appliance should be
mounted to a wall or ceiling only as recommended by the
manufacturer.
19. Power Lines - An outdoor antenna should be bated
from power lines.
20.0utdoor Antenna Grounding - H an outside antenna
is connected to the receiver, be sure the antenna system is
grounded so as to provide some protection against voltage
surges and built up static charges.
Seaion 810 of the National Electric Code,ANSI/NFPA No. 70-
1984, provides information with respect to proper grounding of
the mast and supporting structure, grounding of the lead-in wire
to an antenna disdiarge unit, size of grounding connectors, loa
tion of antenna-discharge unit, connection to grounding elec
trodes, and requirements for die grounding electrode, see Fgure
below.
21. Object and Liquid Entry - Care should be taken so
that objects do not fall and liquids are not spilled into the
endosure through openings.amply with recommended interna
tional global safety standards for tilt and stability properties of
its abinet design.
22. Batteiy Usage CAUTION - To prevent battery leakage
that
n\3f
result in bodily injury, property damage, or damage to
the unit
* Install all batteries correctly, with + and - aligned as marked
on the unit
* Do not mix batteries (old and new or arbon and alkaline,
etc).
* Remove batteries when the unit is not used for a long time.