Perfect Aire 10000PPAC - Manual (Page 12)

INSTALLATION INSTRUCTIONS (CONTINUED)
Water drainage:
- During dehumidifying modes, remove the drain
plug from the back of the unit and install the drain
connector (5/8” universal female mender) with 3/4”
hose (locally purchased). For models without drain
connector, just attach the drain hose to the hole.
Place the open end of the hose directly over the
drain area in your basement floor.
(See Fig. 23 & 24.)
- When the water level of the bottom tray reaches
a predetermined level, the unit beeps 8 times and
the digital display area shows "P1." At this time
the air conditioning/dehumidification process will
immediately stop. However, the fan motor will
continue to operate (this is normal). Carefully move
the unit to a drain location, remove the bottom drain
plug and let the water drain away. (See Fig. 25.)
Restart the machine until the "P1" symbol disappears.
If the P1 symbol will not clear after following the above
instructions and waiting a few minutes after restarting
the machine, call customer service.
Fig.23
Fig.24
Fig.25
NOTE: Be sure to reinstall the bottom drain plug
before using the unit.
11