PRG S400 User Manual 3.1 - Manual (Page 62)

56 PRG SERIES 400 ® POWER AND DATA DISTRIBUTION SYSTEM USER MANUAL
Repositioning Front of House Trunk Connector
The trunk connector on the Front of House Breakout Module can be positioned in one of two locations depending on
whether the unit is to be installed in a rack or used as a stand-alone enclosure.
Parts:
none
Tools:
#2 Phillips screwdriver
WARNING: Remove power before performing any maintenance procedures.
To reposition FOH trunk connector:
Step 1. Disconnect power from Front of House Breakout Module.
Step 2. At trunk connector mounting plate, remove eight screws and pull connector loose. (Plate will still be
connected by wiring.)
Step 3. Rotate mounting plate into new position and re-install screws.
Figure 4-5: Repositioning FOH Breakout Module Trunk Connector
Screw (8)
Trunk Connector
Mounting Plate
Position 1
Position 2
(Other)
(Rack Mount)